Products
IEC 60898-1 Resistance To Mechanical Stress And Shock Tester For Testing Switch Sockets
Products Description
IEC 60898-1 Resistance To Mechanical Stress And Shock Tester For Testing Switch Sockets
Product Information:
The test equipment conforms to the standard requirements of IEC 61009-1:2012, IEC60898-1:2015, etc.
It is used for switch sockets, surface-mounted installation boxes, contactors, molded case AC air circuit breakers, etc., to verify the impact resistance of exposed parts that may be subjected to mechanical impact during normal use.
Test principle: According to the test Eha: the pendulum, the impact element is released freely at a certain height through a 1-meter pendulum, hits the sample at the lowest point in the vertical direction, and through the transformation of gravitational potential energy into kinetic energy, the purpose of impact testing on the sample is achieved.
Features: This equipment, also known as low-energy pendulum impact test device, adopts a floor-standing structure and does not need to be installed. The sample mounting bracket can be adjusted up and down, left, right, and front and rear. At the same time, it can be adjusted around the axis perpendicular to the mounting plate and the mounting plate can rotate around the vertical axis, a total of wuzhou2 adjustable. The swing rod can adjust the release angle through the pivot, so as to achieve the impact on different positions of the front and side of the sample, covering the impact test requirements of most similar products.
Technical Parameters:
Non-enclosed circuit breaker mounting fixture
Panel mount circuit breaker mounting clamps
Table 2 Height of Fall
Model
SN2507
Applicable sample range
Panel mount, rail mount, recessed, panel mount circuit breaker
Impact element head
R10 polyamide, hardness HR100
Impact element mass (equivalent mass)
150±1g(200g)
Mounting bracket quality
10±1Kg
Mounting brackets
Can rotate ±90° around the mounting plate, the mounting plate can rotate ±90° around the vertical axis, X, Y, Z three axes can be adjusted
Position regulation
Bracket X-100～100mm, Y-100～100mm, Z-100～100mm stroke adjustable
Swing pendulum
A steel pendulum with a length of 1000±1mm, a mass of 100±1g, a material outer diameter of 9 mm, and a wall thickness of 0.5 mm
Impact height
0-500mm, scale display (corresponding angle conversion)
Circuit breaker mounting plate
175*175*8 laminated board
Specimen fixture
Dimension
860mm×650mm×2000mm
Weight
About 140 KG
Energy /J
0.14
0.2
(0.3)
0.35
(0.4)
0.5
0.7
1
2
5
10
20
50
Equivalent Mass /kg
0.25
(0.2)
0.25
(0.2)
0.25
(0.2)
(0.2)
0.25
0.25
0.25
0.5
1.7
5
5
10
Height of Fall ±1%mm
56
(100)
80
(150)
140
(200)
(250)
200
280
400
400
300
200
400
500
Note 1, see note 3.2.2; Note 2, the energy unit of this part of the joule (J) is derived from the standard gravity acceleration (g), the whole value of g round: 10m / s2.
