Products
VW 80000-2017 Motor Vehicle Components Condensation Test Chamber
Products Description
VW 80000-2017 Motor Vehicle Components Condensation Test Chamber
Product overview:
It simulates the condensation on electronic modules in motor vehicles. It is meant to evaluate the robustness of electronic modules with respect to condensation.
4 movable casters
Using MCGS programmable temperature and humidity controller (7-inch 16-bit true color touch screen); English menu operation mode, 120 groups memory program, each program group contains 1200 program segments, all loops, up to 999 times. Controller: The controller with English display has the function of self-diagnosis, prompts the cause of failure and treatment method, records test data and process, and has a standard RS232 or U disk communication interface.
This condensation test chamber meets the condensation test requirements of .VW 80000-2017,DIN EN ISO 6270-2, GS95011-4-2004, DIN 50017, etc.
Technical parameters:
Size
Working area
600*500*830mm(W*D*H)
External size
Approx. 1200*750*1300mm(W*D*H)
Performance
Temperature range
Ambient～60℃ (common used temperature: 38℃/49℃/60℃)
Temperature fluctuation
≤1℃ (≤±0.5℃, tested according to GB/T5170-2008)
Temperature accuracy
0.1 ℃
Temperature deviation
±2℃
Humidity range
100%RH (+0%, -5%, during condensation)
Heating rate
≥10℃/30min (with load of 20KG steel,meet condensation test of VW80000-2013)
Cooling rate
≥65℃/75min (with load of 20KG steel,meet condensation test of VW80000-2013)
Temperature and humidity measuring parts
Use high-precision A-level PT100 temperature sensor for temperature measurement
Heating method
Electric heating, PID adjustment, actuator: solid state relay
Heating system
New-type ceramic heating frame, with heating wire imported from Germany in the middle, thick wire diameter, high temperature resistance, dry burning resistance
Humidification system
External humidification, the humidification tube adopts U-shaped design and over-temperature probe hole,
Dehumidification system
Using evaporator coil dew point temperature laminar flow contact dehumidification method
Water supply system
The humidification water supply adopts automatic control, and the residual water can be recycled, saving water and reducing consumption
Cooling System
Fully enclosed Tecumseh compressor imported from France, using R404 and R23 DuPont environmentally friendly refrigerant
Wind tunnel
Forced circulating air duct to ensure uniform temperature in the working room; heaters, coolers, and temperature sensors are installed in the air duct
Condensate outlet
With outlet holes for studio condensate and unit condensate
Timing range
1～9999 mins/hours
Materials
Outer wall material
A3 iron plate sprayed
Inner wall material
SUS304 Stainless steel plate
Insulation material
Rigid polyurethane foam
Observation window
Three-layer explosion-proof tempered glass window
Lead hole
2 Φ100mm lead holes, with cover and soft plug, located on the left and right walls of the chamber
Sample rack
2PCS, SUS304 stainless steel material, adjustable spacing storage track, sample rack can be adjusted up and down according to needs, evenly bearing 30KG/layer.
Light
There is a lighting lamp on the top of the observation window, which is controlled by the switch outside the door, which is convenient and clear to observation
Movable casters
Humidification tank
High quality 304 stainless steel water tank
Control element
