Products
IEC 60335-1 Clause 25.15 Cord Anchorage Pull Force And Torque Tester PLC Control
Products Description
IEC 60335-1 Clause 25.15 Cord Anchorage Pull Force And Torque Tester PLC Control
Product information:
The Cord Anchorage Force and Torque Test Equipment is designed and manufactured according to the standard requirements of IEC60884-1 clause 23.2, IEC60745-1:2006, IEC60335-1 clause 25.15, IEC60598-1 clause 5.2.10.3, IEC60065 clause 16.5 and etc.
The tester is used to conduct two tests of tension and torque at the terminals of appliances (lamps) with power cords, appliances intended to be permanently connected to fixed wiring with flexible cords, and power cords such as household appliances, medical equipment, etc.
The test method is to make a mark at the position of the wire sample 20mm from the fixing device, gently apply the tension 25 times (or the number of times required by other standards) at a rate of 1 time/second, and apply a torque near the exit of the appliance for 1 minute. After the test, the displacement of the marking position of the wire shall not exceed 2mm.
Technical Parameters:
Standard
IEC60884-1 Clause 23.2
voltage
220V(AC)50Hz
Electric control method
PLC+ touch screen
Drive method
Motor and electromagnet drive
Test station
Single station, vertical and horizontal cannot be tested at the same time
Sample clamping method
Mechanical clamping, clamping point height can be adjustable
Tensile weight
10N: 1 PC, 20N: 3 PC, 30N: 2 PC (The tester can test the tensile weight of 30N, 40N, 60N, 80N, 100N, and 120N)
Tension application method
Horizontal or vertical (optional)
Torque weight
4N, 5N, 7.5N, 12.5N, 17.5N, 21.25N (The tester can test the torque weight of 0.08N∙m, 0.1 N∙m, 0.15 N∙m, 0.25 N∙m, 0.35 N∙m, and 0.425 N∙m)
Test times
0~999999 times, can be preset
Rally frequency
1s/time, with tension sensing clip which can verify the tension retention time
Torque time
0-9999.9 seconds, can be preset
Equipment size and weight
WDH=650×550×1200mm, approx. 110kg
