Products
IEC 62196-1 Rewireable Plugs And Vehicle Connector Drop Testing Equipment
Products Description
IEC 62196-1 Rewireable Plugs and Vehicle Connector Drop Testing Equipment
Product information:
This testing device is required by IEC 62196-1Ed.4CDV 2020 clause 26.3, fig 19.
It is used to test the mechanical strength of rewirable plugs and vehicle connector which is equipped with flexible cable.
Test principle: The free end of the cable and an additional rope or other flexible means, etc., attached to the flexible cable, both having a total length of 2,25 m, is fixed to a wall at a height of 1 m above the floor.
The sample is held so that the cable is horizontal and then it is allowed to fall on to a concrete floor. This is done eight times; the cable being rotated through 45° at its fixing each time.
Technical parameters:
1. The height of dropping:1000mm
2. Dropping times:8
3. Rotating angle:45°, it can be rotated in all sides.
4. Size:L*W*H 2300*500*860mm
Test procedures (Excerpt from IEC 62196-1Ed.4CDV 2020 clause 26.3):
Non-rewirable plugs and vehicle connectors are tested with a small section (approximately 200 mm) of the flexible cable as delivered.
Drop height
1000mm
Dropping times
8times
Rotating angle
45°, it can be rotated in all sides
Equipment size
L*W*H 2300*500*860mm
Conforms to standard
IEC 62196-1Ed.4CDV 2020 clause 26.3, fig 19.
The free end of the cable and an additional rope or other flexible means, etc., attached to the flexible cable, both having a total length of 2,25 m, is fixed to a wall at a height of 1 m above the floor, as shown in Figure 19.
The sample is held so that the cable is horizontal and then it is allowed to fall on to a concrete floor. This is done eight times; the cable being rotated through 45 ° at its fixing each time.
