Products
IEC 62368-1 Annex D.1 Impulse Voltage Generator Test Equipment
Products Description
IEC 62368-1 Annex D.1 Impulse Voltage Generator Test Equipment
Product Information:
The impulse voltage generator conforms to the standards as follows.
IEC 62368-1 Annex D.1 Circuit 1
Technical Parameters:
1. Voltage integrated wave: 10/700us (when the output of the waveform generator is open).
2. Integrated wave output impedance:40W±10%
3. Integrated wave output voltage waveform peak value: 0.1~6kV
4. Output polarity: positive, negative
5. Impulse output mode: automatic.
6. Impulse times: 1~9999 times
7. Impulse interval time: 30~99 seconds (please note: the minimum interval time for 10/700ms wave is 30s)
9. Weight: about 30kg
10. Output waveform definition
11. Voltage wave: Front time:T1=1.67T=10ms±30%; Time to half value:T2=700ms±20%
Important Safety Precautions
The impulse voltage generator generates high-voltage pulses during operation. For safety, please read this manual and use this equipment correctly. Please pay attention to the following points during use:
(1) Do not use this equipment when your hands are wet or the relative humidity exceeds 75%.
(2) Because there is a high-voltage pulse applied to the terminal (impulse out), please confirm that the high-voltage power supply is disconnected when you want to change the wiring (HV.POW light is off) before proceeding.
(3) The operation must strictly follow the instruction manual.
(4) Although electric shocks are rarely encountered when operating this equipment, for safety, do not eat during operation to prevent accidental obstruction of eating caused by electric shocks.
(5) This equipment uses a vacuum contactor to generate voltage pulses. To ensure the life of the vacuum switch, do not turn on the high voltage when the equipment is not being tested, especially do not continuously trigger the vacuum contactor under high pressure.
(6) With high voltage inside, please do not disassemble or open the shell to work at will.
(7) It contains high voltage, please do not disassemble or open the shell to work.
Configuration List
Gun type single head
Black and red wires
Certificate of Quality
IEC 61180-1:2016 < High-voltage test techniques for low voltage equipment - Part 1: Definitions, test and procedure requirements, test equipment> clause 7.
IEC60335-1:2016 clause 14.
IEC60950-1:2013 clause1.5.7.2, 1.5.7.3,2.10.3.9,6.2.2.1,7.4.2,7.4.3, G5, Annex N.
IEC60065:2014 clause13.3.4, Annex J.5, Annex K.
Item
Name
Quantity
Unit
Remark
Main device
Impulse Voltage Generator
1
SET
Accessories
Power cord
1
PC
Ground wire
1
PC
2 m
EUT output connection wire
2
PCS
Terminals block
1
PC
6P
Coaxial cable
1
PC
For connecting to Oscilloscope
Document
User’s manual
1
copy
Warranty card
1
copy
1
Copy
