Products
IEC60529-2013 IPX3/4/5/6 Spray Nozzle And Hose Nozzle Water Spray Test System
Products Description
IEC60529-2013 IPX3/4/5/6 Spray Nozzle and Hose Nozzle Water Spray Test System
Standard For IPX3/4/5/6 Spray Nozzle and Hose Nozzle Water Spray Test System:
IEC 60529 -2013 “Degrees of protection provided by enclosure (IP code)” IPX1, IPX2, IPX3and IPX4
IEC 60598-1-2017 “Luminaries-Part1: General requirements and tests”
Application For IPX3/4/5/6 Spray Nozzle and Hose Nozzle Water Spray Test System:
To verify the protective performance of the enclosure for electronic and electrical products, automobiles, motorcycle parts, household appliances, seals and lamps under water spraying and splashing at degree IPX3 & IPX4 and water jets at degree IPX5 and IPX6.
Technical Parameters For IPX3/4/5/6 Spray Nozzle and Hose Nozzle Water Spray Test System:
Power supply: AC380V±5%/50Hz, 5KVA, or match client’s local power supply requirements.
Use place: temperature 15-35 ° C, relative humidity 25%-75%, atmospheric pressure 86 ~ 106kpa (860 mbar -1060 mbar), there should be equipped with lighting and waterproof leakage switch (or socket), the ground needs to be flat, and the water intake and drainage function should be good.
Water source: clean water or tap water without impurities.
IPX3 & IPX4
Parameters of Spray Nozzle
Outer diameter: Ф102mm, spherical diameter: SФ75.5mm, 1 hole at the center, 2 inner circles of 12 holes at 30° pitch,4 outer circles of 24 holes at 15° pitch , total 121 holes of Ф0.5mm, made of brass.
Water Flow
10L/min±5%, flow meter is adjustable through rotameter, electronic flowmeter is optional
Pressure
50～150Kpa, the pressure gauge measuring range: 0～0.25Mpa
Moving Shield
Made of aluminum, can be detachable
Water Spray Directions
The angle of water spraying can be adjusted
IPX5 & IPX6
Parameters of Hose Nozzle
IPX5: Ф6.3mm; IPX6: Ф12.5mm
Delivery Rate
IPX5: 12.5±0.625L/min; IPX6: 100±5 L/min, flow meter is adjustable through rotameter, electronic flowmeter is optional
Distance from Nozzle to Enclosure Surface
2.8m ((The distance from the nozzle to the center surface of the turntable, standard requires 2.5-3m)
Water Jet Directions
The angle of water jetting can be adjusted
General
Control & Operation
Push-button operation (PLC and touch screen intelligent control system is optional)
Nozzle Fixed Method
Spray nozzle and hose nozzle are fixed on the support
Pressure Gauge
0~0.25MPa, can be displayed
Test Duration
0.01S～99.9 min, can be preset
Turntable
Diameter: Φ600mm, rotation speed: 1r/min, bearing capacity: ≤50kgs
Water Storage Tank
This test system adopts open type structure, the test water is not recycled. The test system is equipped with an approximately 500L stainless steel water storage tank. The water storage tank is equipped with a water level float valve to automatically control the water inlet, and has high and low water level alarm detection, to effectively prevent the pump from being damaged due to dry water. The water storage tank and electrical control part are integrated.
Safety Protection
Phase sequence protection, leakage protection, water shortage protection, abnormal protection.
